Release Notes/Solved items Version 5.3.2

RadiMation version 5.3.2

• #2640: CE Multiband test is giving ‘horizontal’ instead of the lisn line
• #2633: Button in the environmental data window to use the same value as the last test for all the parameters
• #2614: Question: Which value for ALC is set inside the Kalmus 757LC?
• #2613: Report generation is slow when codes are included that are not present in the data file
• #2612: ||EUT|ENVIRONMENT|| is not replaced with the data in a report
• #2605: driver: Frankonia stripline, 90Ohm, 1GHz SR90/1000
• #2585: List of selected equipment is not sorted by default
• #2578: Radimation stops when not used for more then 10 minutes
• #2576: URV5 is returning measurement values in W instead of dBm
• #2572: Multiband immunity should ask on which location it should continue if automatic mode is enabled
• #2569: G-tem measurement is giving overflow error
• #2555: Driver ESN is not set up correctly
• #2549: Remove support for exotic report generator editors
• #2543: The port type selected in the cable configuration is not shown in the EUT window
• #2540: Crash when environmental data button is clicked in the TSF that is included in a sequence
• #2537: What is the usage of "Check Extension" in the report generator
• #2534: Typing error in manual mode window
• #2531: AR PM 2002 gives an 'Unknown Error' after zeroing
• #2530: driver: Schaefer Controller (Turn Table + changing polarisation)
• #2528: Environmental Data is some times not asked before testing
• #2523: Forward powermeter is not included in test initialization of a multiband immunity test
• #2518: Multiband frequency list is not taking the unit of the frequency column into account
• #2497: trying esi 40 driver on esi 26 is crashing the software.
• #2495: R&S ESI series analyzers hold the GPIB bus, so a GPIB delay should be used between GPIB calls of different device drivers
• #2490: Environmental data is empty when test results are reopened
• #2481: driver: NI-6221 DAQ card
• #2480: driver: NI-PCI-6014 Analog DAQ
• #2444: Include A/m as unit for magnetic flux density
• #2441: Measure more then 100 sweeps
• #2439: Possibility to select multiple cables/attenuations for a cable in the test-site
• #2322: Multiple correction files for RE chamber test
• #1837: Measure more then 100 peaks.
• #1444: Perform Immunity test from high to low frequency (Reverse frequency sweeping)
• #663: Turntable support in Radiated Immunity
• #484: Frequency steps per decade or frequency steps per octave not possible
• #285: Advanced Data Shower om alle data in de Test files te tonen