Equipment: Difference between revisions
Jump to navigation
Jump to search
(New page: A piece of Equipment is a device that is used to perform EMC tests. Not to be confused with the Equipment Under Test which is being tested. RadiMation knows the following types of equ...) |
No edit summary |
||
| Line 14: | Line 14: | ||
* [[Calibration Jig]] | * [[Calibration Jig]] | ||
* [[Current Sensor]] | * [[Current Sensor]] | ||
* [[Field Sensor]] | |||
* [[AD Convertor]] | |||
* [[LISN]] | |||
* [[Output Box]] | |||
* [[Pre-Amplifier]] | |||
* [[Climat Chamber]] | |||
* [[ESD Gun]] | |||
* [[EFT Generator]] | |||
* [[Surge Generator]] | |||
* [[Absorbing Clamp]] | |||
* [[Clamp Mover]] | |||
* [[Switch Matrix]] | |||
* [[EUT Controller] | |||
* [[Oscilloscope]] | |||
* [[Resistor]] | |||
* [[Multimeter]] | |||
* [[Network Analyser]] | |||
General information of [[Equipment Manuals]]. | General information of [[Equipment Manuals]]. | ||
Revision as of 13:52, 21 June 2007
A piece of Equipment is a device that is used to perform EMC tests. Not to be confused with the Equipment Under Test which is being tested.
RadiMation knows the following types of equipment:
- Spectrum Analyser
- Signal Generator
- Amplifier
- Coupler
- Power Meter
- Antenna
- Cable
- Antenna Tower
- Turn Table
- Injection Clamp
- Calibration Jig
- Current Sensor
- Field Sensor
- AD Convertor
- LISN
- Output Box
- Pre-Amplifier
- Climat Chamber
- ESD Gun
- EFT Generator
- Surge Generator
- Absorbing Clamp
- Clamp Mover
- Switch Matrix
- [[EUT Controller]
- Oscilloscope
- Resistor
- Multimeter
- Network Analyser
General information of Equipment Manuals.