Configurable XYZ Positioner
Jump to navigation
Jump to search
The Configurable XYZ Positioner device driver is a Positioner which is supported by RadiMation®.
Configurable XYZ Positioner[edit]
This driver can be configured to send commands to an EUT X, Y and Z-axis Positioner. It will be used in a Radiated Emission test with the location type GTEM configured. Below an overview of the commands to configure:
Initialisation and Check[edit]
 Reset
|
The reset command sent during the initialisation phase |
| Init
|
The command sent during the initialisation phase |
| Get ID
|
The command sent to request the identifier of the device, e.g. *IDN? |
| Returned ID
|
The response of GET ID, this can either be the returned value or an regular expression |
| Deinit
|
The command sent during the de-initialisation phase |
| Wait for Completion after sending command
|
With this command the configured commands below will also send an *OPC? command to query if the operation is completed |
XYZ Positioner[edit]
| X Position
|
The command which will start to move the EUT in the X Position |
| X Position Stop
|
The command which will be sent after "X Position" command is sent and the configured waiting time is elapsed |
| Y Position
|
The command which will start to move the EUT in the Y Position |
| Y Position Stop
|
The command which will be sent after "Y Position" command is sent and the configured waiting time is elapsed |
| Z Position
|
The command which will start to move the EUT in the Z Position |
| Z Position Stop
|
The command which will be sent after "Z Position" command is sent and the configured waiting time is elapsed |
| Waiting time
|
The time to wait between the '...'-Position and '...'-Position Stop. Specified in milliseconds (ms). This time will only be used when the start command is configured. |