The Configurable Amplifier device driver is a Amplifier which is supported by RadiMation®.
Configuration[edit]
The following tabs are available in the advanced configuration of the Configurable Amplifier:
The frequency range of the Configurable Amplifier as provided by the manufacturer is shown and selected as default. It is possible to overrule these frequencies and to manual adjust the allowed frequency range of the Configurable Amplifier.
 Use default start frequency
|
If the checkbox is checked, the default start frequency will be used as the lowest usable frequency in a test for this device.
|
| Custom start frequency
|
If the Use default start frequency checkbox is unchecked, another start frequency (expressed in MHz) can be specified. The customized start frequency will then be used as the lowest usable frequency in a test for this device. The customized frequency can be a limitation or an extension of the default start frequency.
|
| Use default stop frequency
|
If the checkbox is checked, the default stop frequency will be used as the highest usable frequency in a test for this device.
|
| Custom stop frequency
|
If the Use default stop frequency checkbox is unchecked, another stop frequency (expressed in MHz) can be specified. The customized stop frequency will then be used as the highest usable frequency in a test for this device. The customized frequency can be a limitation or an extension of the default stop frequency.
|
Specifying a different frequency range can be useful if for example:
- A device (like a coupler, antenna, injection device, cable, etc...) is still useable (but out of specification) outside the standard suggested frequency range.
- An external mixer is used to measure an extended frequency range.
- An up- or down-convertor is used to shift the frequency range.
- A newer model of a device is present that has an extended frequency range, and still uses the same remote control commands.
Be careful changing these setting as RadiMation® is no longer able to verify if the Configurable Amplifier is used outside frequency range that is specified by the manufacturer. This may result to serious damage of your measurement device.
Template:FrequencyRangeConfigurableDevice
| Initialisation and Check
|
| Init
|
The Init code that needs to be send to device. When left blank no command will be send.
|
| Get ID
|
The code that needs to be send to device to get the identification back. A common used SCPI command is *IDN?. When left blank no command will be send.
|
| Returned ID
|
The code that is send back as a return on the Get ID code. When left blank no check will be performed.
|
| Deinit
|
The Deinit code that needs to be send to device. When left blank no command will be send.
|
|
| Operation
|
| Power On
|
The power on code that needs to be send to device. When left blank no command will be send.
|
| Power Off
|
The power off code that needs to be send to device. When left blank no command will be send.
|
| Standby
|
The standby code that needs to be send to device. When left blank no command will be send.
|
| Operate
|
The operate code that needs to be send to device. When left blank no command will be send.
|
|
Example[edit]
For this example the driver will be used to control the Milmega Controller AC-001.
Summary of control commands
| Description
|
Command
|
Parameters
|
| Output logic
|
OUT1
|
0 = RF STANDBY
1 = RF ON
|
| Output logic
|
OUT4
|
0 = LINE STANDBY
1 = LINE ON
|
