RadiMation Application Note 154

How to perform a MIL-STD CS114, Conducted susceptibility, bulk cable injection test

This application note explains how the MIL-STD CS114, Conducted susceptibility, bulk cable injection test can be performed with RadiMation^®

The exact requirements and test methods for the CS114 are specified in the MIL-STD-461.

Necessary equipment

The following devices are necessary to execute this test:

• Signal generator
• Amplifier
• Coupler
• Forward power meter
• Reflected power meter (optionally)
• Current sensor
• Sensor power meter / Analyser
• 50 Ohm load
• 50 Ohm attenuator
• LISN
• Current injection device
• Current injection calibration jig (Calibration fixture)
• Cable drivers with corrections

The sensitivity of an EUT to incoming electromagnetic interference. This is equivalent to the term Immunity. RadiMation® always uses the term Immunity.

Line Impedance Stabilisation Network