Schneider Electric Modbus
The Schneider Electric Modbus device driver is a AD Converter which is supported by RadiMation®.
The Schneider Electric Modbus is a device driver that can be configured to retrieve specific registers from a Modbus device, and present the values from those registers as EUT monitoring inputs in RadiMation®.
The following tabs are available in this device driver:
On the Communication tab, the desired communication method can be selected and configured. Depending on the selected method, additional relevant settings are shown and can be configured.
 Communication Streams
|
Selects the medium or method that should be used to communicate with the device. Depending on the capabilities of the device this can be one or more of:
See the Communication Settings in Chapter 15, on how to configure each of these methods. |
On the Identification tab, the expected *IDN? response of the test and measurement device can be configured. It is used to determine if the correct test and measurement device is connected.
| Expected response
|
The expected *IDN? response of a device. It can be changed in the case the commands are the same for another device for which no RadiMation® driver is available yet. |
| Restore default
|
Restores the original Exepected response. |
On the Modbus tab, the selection of the modbus module, and the communication protocol to access it can be selected. The following settings are available:
| Modbus address
|
The module address of the Modbus module from which the registers should be read. |
| Modbus type
|
Selects the communication type to communicate with the modbus module.
|
