Release Notes/Solved items Version 2024.2.7
Jump to navigation
Jump to search
RadiMation version 2024.2.7[edit]
- #12918: When pressing retry perform a full device driver check
- #14893: Driver: Exodus AMP2070A
- #14894: Driver: Exodus AMP2071A
- #15414: Driver: Rohde & Schwarz UPV
- #15626: Re-activate write termination to use implicit GPIB EOI
- #15670: R&S FPC1500 driver improvements
- #15897: Add hidden member to allow selection of DC high impedance coupling
- #15994: Fix Attachment is not included in report with ||EUT|ATTACHMENT 1 CONTENTS||
- #16036: Send the MPOV command to control the 0-10V DC output of the NX series VDI generator
- #16044: Support the Keysight N9000 series Accelerated Time Domain (ATD) scan mode
- #16073: Improve calibration file frequency range checks and show file name in related errors
- #16107: Support the "Coupling NX5 bs-3-480-32" external surge coupling device
- #16127: NX-series add coupling device bs-3-480-32
- #16139: Narda EMD-100 driver
- #16161: Maturo FCU3.0: add default communication configuration
- #16195: Log memory usage
- #16203: Perform the full device driver checks when the test initialisation is retried on error
- #16216: Questions about which LISN insertion loss corrections should be applied
- #16223: Add specialized Milmega 80RF1000 series amplifier driver without band selectio
- #16223: Improvements for the Milmega amplifier state detection
- #16242: Implemented the missing function GetPointsInTrace for RTE/RTO oscilloscope driver
- #16245: Use correct measure trigger configuration for Keysight 344xx
- #16273: DMM7510 now uses fixed aperture at detector bw 3 or 30
- #16278: Limit the minimal allowed carrier level based on the stepped attenuator option
- #16285: Do not set the changeflag of the limit line file when only opened
- #16291: Allow disabling of resetting the Agilent 33522B when initialized
- #16299: RTE/RTO use STAT:OPER:COND? to detect if the measurement is finished
- #16310: Driver: ETS-Lindgren EMSense 7007-301
- #16312: provide details about the amplifier linearity check
- #16313: Fix Maturo MC32 rotates during measurements without being told.
- #16320: GPIB-Board is not installed or configured incorrectly (GPIB: ENEB)
- #16322: Could not open connection to networked device
- #16325: AR2500A225 amplifier cooling fault raised an interlock error when starting test,
- #16327: IO communication error during test
- #16340: Add pulse modulation measurement support on Agilent N9010A
- #16344: Improve surge sequence progres calculation of the NX series
- #16345: Do not show the identification panel for configurable device drivers
- #16246: Corrected and improved the calculation of power levels during the UFA calculation using constant field 61000-4-20 method.
- #16352: Add delays to the Milmega 80RF1000 series amplifier driver
- #16369: Driver: R&S NRP67S
- #16375: Implement speed control for the Frankonia table and towers
- #16410: Set detector measure time when measuring zero-span receiver mode with analyzer
- #16424: Fix for firmware update RPR4000 series
- #16428: Fixes related to the AR FP7018 manual tuned field sensor driver
- #16445: Do not stage triggered measurement while the zero operation is running when measuring using a VI instrument
- #16488: Fix allow pulse modulated power measurements with the Agilent N9010A