Talk:RadiMation Application Note 100

I do have some suggestions to further improve the application note:

• The table of contents is shown twice
• Isn't it better to have a screenshot of the result in the introduction. It will make it clear how the result will be.
• The 'ScreenElement' macro can be used to indicate button names. I already modified it on a few locations. But not yet on all locations
• The 'Remove' button and the 'Custom Status window' checkbox are not explained.
• The section of 'Horizontal' or 'Vertical' doesn't show any text. Maybe it is better to provide a screenshot of the enhanced status window for each situation. Then the difference will be very clear...
• I Suggest to include a screenshot of an example after the 'List Of measurement parameters'.
• Then at the end of the document it is very helpful to show a screenshot during a test, where also the enhanced status window is shown
• In that last section it should also be explained that if the enhanced status window is closed, it can be shown again from the 'Window' menu.

Joro 10:01, 15 July 2015 (UTC)

• The table of contents is shown twice

-> removed the additional table of contents.

• Isn't it better to have a screenshot of the result in the introduction. It will make it clear how the result will be.

-> agreed inserted two screenshots of possible end results.

• The 'ScreenElement' macro can be used to indicate button names. I already modified it on a few locations. But not yet on all locations.

-> Good idea, will update the whole text and use it from now on.

• The 'Remove' button and the 'Custom Status window' checkbox are not explained.

-> Extended the explanation to include this.

• The section of 'Horizontal' or 'Vertical' doesn't show any text. Maybe it is better to provide a screenshot of the enhanced status window for each situation. Then the difference will be very clear...

-> Already had those screenshots ready to be implemented. Updated the text.

• I Suggest to include a screenshot of an example after the 'List Of measurement parameters'.

-> Already had this screenshots ready to be implemented. Updated the text.

• Then at the end of the document it is very helpful to show a screenshot during a test, where also the enhanced status window is shown

- > I agree and will create such screenshot and description.

• In that last section it should also be explained that if the enhanced status window is closed, it can be shown again from the 'Window' menu.

- > I agree, however I was not able to reopen this window after it was closed...

Sast 11:17, 14 August 2015 (UTC)