Signal Offset With Receiver

From RadiWiki
Revision as of 12:13, 20 December 2007 by Jewe (talk | contribs)
Jump to: navigation, search

this document is describing a possible solution for the frequency offset of the signal generator and the receiver.


Receiver Settings
RBW 200 Hz
Step size 200 Hz

Note: The step frequency of 200 Hz is taken increase the impact, to get the right frequency use RBW/2 or less as step frequency.


Signal Generator Settings
Carrier Frequency 100 kHz


With these settings we get the following emission spectrum: ReceiverOffSetExample.PNG

As you can see the emission is starting a little bit before the 100 kHz.


Marconi 2024 Reference connector

Marconi Ref Connector.JPG


R & S Esi 40 Reference connector

ESI Ref Connector.JPG