RadiMation Application Note 133

How to use EUT monitoring in Pulsed Immunity MultiBand EFT & Surge RadiMation^®

In this application note we shall explain how RadiMation^® can be configured to measure EUT monitoring inputs in Pulsed Immunity MultiBand EFT & Surge.

EUT monitoring in Pulsed Immunity MultiBand EFT & Surge

The EFT/Surge MB tests have the abillity to measure EUT monitoring inputs during the active test sequences.
The measured data can be seen in a graph and table view on the Data-tab.
If the min/max range is enabled for the monitor inputs, RadiMation shall display a list of the measurements measured out of range on the Peaks-tab found on the Data window.

For more information on how to configurate the EUT monitor inputs, see https://wiki.radimation.com/wiki/index.php/Chapter_10

Ambient Measurement

To indicate the stable situation during an EFT/SURGE MB tests an ambient measurement phase is performed before the start of each configured sequence.
The ambient measurement phase shall be performed over the default duration of 3 seconds.

Equipment Under Test

The ability of an EUT to be immune to incoming electromagnetic interference. This is equivalent to the term susceptibility that is used by some standards.

Electrical Fast Transients

Multiband: Tests that allow more flexible test configurations, where multiple bands with different settings can be specified in a single TSF.

Megabyte: 1 million bytes.