Difference between revisions of "Configurable XYZ Positioner"
Line 8: | Line 8: | ||
[[File:Configurable_XYZ_Positioner.PNG]] | [[File:Configurable_XYZ_Positioner.PNG]] | ||
+ | |||
+ | ===Configurable XYZ Positioner=== | ||
+ | This driver can be configured to send commands to an EUT X, Y and Z-axis Positioner. It will be used in a Radiated Emission test with the location type GTEM configured. | ||
+ | Below an overview of the commands to configure: | ||
+ | |||
+ | ====Initialisation and Check==== | ||
+ | {{ScreenElementDescription|Reset|The reset command sent during the initialisation phase}} | ||
+ | {{ScreenElementDescription|Init|The command sent during the initialisation phase}} | ||
+ | {{ScreenElementDescription|Get ID|The command send to request the identifier of the device, e.g. *IDN?}} | ||
+ | {{ScreenElementDescription|Returned ID|The response of GET ID, this can either be the returned value or an regular expression}} | ||
+ | {{ScreenElementDescription|Deinit|The command sent during the de-initialisation phase}} | ||
+ | {{ScreenElementDescription|Wait for Completion after sending command|}} | ||
+ | |||
+ | |||
+ | ====XYZ Positioner==== | ||
+ | {{ScreenElementDescription|X Position| ... }} | ||
+ | {{ScreenElementDescription|X Position Stop| ... }} | ||
+ | {{ScreenElementDescription|Y Position| ... }} | ||
+ | {{ScreenElementDescription|Y Position Stop| ... }} | ||
+ | {{ScreenElementDescription|Z Position| ... }} | ||
+ | {{ScreenElementDescription|Z Position Stop| ... }} | ||
+ | {{ScreenElementDescription|Waiting time| ... }} |
Revision as of 14:47, 20 November 2019
The Configurable XYZ Positioner device driver is a Positioner which is supported by RadiMation®.
Configurable XYZ Positioner
This driver can be configured to send commands to an EUT X, Y and Z-axis Positioner. It will be used in a Radiated Emission test with the location type GTEM configured. Below an overview of the commands to configure:
Initialisation and Check
Reset | The reset command sent during the initialisation phase |
Init | The command sent during the initialisation phase |
Get ID | The command send to request the identifier of the device, e.g. *IDN? |
Returned ID | The response of GET ID, this can either be the returned value or an regular expression |
Deinit | The command sent during the de-initialisation phase |
Wait for Completion after sending command |
XYZ Positioner
X Position | ... |
X Position Stop | ... |
Y Position | ... |
Y Position Stop | ... |
Z Position | ... |
Z Position Stop | ... |
Waiting time | ... |