Difference between revisions of "Device Types"
| Line 1: | Line 1: | ||
| + | = Amplifier = | ||
| + | The amplifier is used to generate power for immunity tests | ||
| + | All supported amplifier devices can be found [[:Category:Amplifier|here]] | ||
| + | |||
| + | = Antenna = | ||
| + | The antenna is used to send or receive signals | ||
| + | All supported antenna devices can be found [[:Category:Antenna|here]] | ||
| + | |||
| + | = Antenna Tower = | ||
| + | The antenna tower is used to move the antenna in height and change the polarisation | ||
| + | All supported antenna tower devices can be found [[:Category:Antenna Tower|here]] | ||
| + | |||
| + | |||
= Signal Generator = | = Signal Generator = | ||
The signal generator is used to generate power for immunity tests | The signal generator is used to generate power for immunity tests | ||
Revision as of 11:32, 19 December 2007
Contents
Amplifier
The amplifier is used to generate power for immunity tests All supported amplifier devices can be found here
Antenna
The antenna is used to send or receive signals All supported antenna devices can be found here
Antenna Tower
The antenna tower is used to move the antenna in height and change the polarisation All supported antenna tower devices can be found here
Signal Generator
The signal generator is used to generate power for immunity tests All supported signal generator devices can be found here
Power meter
The power meter is used to monitor the generated power for immunity tests, depending on the test this device can be used for:
- Forward power measurement.
- Reflected power measurement.
- Out power measurement.
- Power measurement at the current sensor.
All supported power meter devices can be found here
A/D converter
The A/D convertor is used to monitor the EUT during testing. All supported A/D converter devices can be found here
Multimeter
The multimeter is used to monitor voltage over a coil during MIL STD testing. All supported multimeter devices can be found here
