Difference between revisions of "Equipment"
(New page: A piece of Equipment is a device that is used to perform EMC tests. Not to be confused with the Equipment Under Test which is being tested. RadiMation knows the following types of equ...) |
|||
| Line 14: | Line 14: | ||
* [[Calibration Jig]] | * [[Calibration Jig]] | ||
* [[Current Sensor]] | * [[Current Sensor]] | ||
| + | * [[Field Sensor]] | ||
| + | * [[AD Convertor]] | ||
| + | * [[LISN]] | ||
| + | * [[Output Box]] | ||
| + | * [[Pre-Amplifier]] | ||
| + | * [[Climat Chamber]] | ||
| + | * [[ESD Gun]] | ||
| + | * [[EFT Generator]] | ||
| + | * [[Surge Generator]] | ||
| + | * [[Absorbing Clamp]] | ||
| + | * [[Clamp Mover]] | ||
| + | * [[Switch Matrix]] | ||
| + | * [[EUT Controller] | ||
| + | * [[Oscilloscope]] | ||
| + | * [[Resistor]] | ||
| + | * [[Multimeter]] | ||
| + | * [[Network Analyser]] | ||
General information of [[Equipment Manuals]]. | General information of [[Equipment Manuals]]. | ||
Revision as of 13:52, 21 June 2007
A piece of Equipment is a device that is used to perform EMC tests. Not to be confused with the Equipment Under Test which is being tested.
RadiMation knows the following types of equipment:
- Spectrum Analyser
- Signal Generator
- Amplifier
- Coupler
- Power Meter
- Antenna
- Cable
- Antenna Tower
- Turn Table
- Injection Clamp
- Calibration Jig
- Current Sensor
- Field Sensor
- AD Convertor
- LISN
- Output Box
- Pre-Amplifier
- Climat Chamber
- ESD Gun
- EFT Generator
- Surge Generator
- Absorbing Clamp
- Clamp Mover
- Switch Matrix
- [[EUT Controller]
- Oscilloscope
- Resistor
- Multimeter
- Network Analyser
General information of Equipment Manuals.
