Difference between revisions of "Hidden Advanced Device Driver settings"
(→Example 1) |
|||
Line 32: | Line 32: | ||
As you can see we have now modified the value of the parameter(s). | As you can see we have now modified the value of the parameter(s). | ||
+ | |||
+ | =Example 2= | ||
+ | Modify the frequency range of the Bonn BLWA 0820-160/75/50D. | ||
+ | [Frequencies] | ||
+ | StartFrequency=1E+009 | ||
+ | StopFrequency=2.7E+009 | ||
+ | |||
+ | As you can see we have now modified the value of the StopFrequency parameter. | ||
{{Warning|Any change and/or modification to these advanced options, can result in unexpected results and/or incorrect measurement results. Changes in these advanced options should be verified and checked very carefully!}} | {{Warning|Any change and/or modification to these advanced options, can result in unexpected results and/or incorrect measurement results. Changes in these advanced options should be verified and checked very carefully!}} | ||
[[Category:RadiMation]] | [[Category:RadiMation]] |
Revision as of 10:05, 15 September 2014
Contents
Question
The RadiMation support department has asked me to changed a hidden Advanced device driver option. How can this be done?
Answer
Normally it is required to first perform the following steps:
- Close RadiMation®.
- Download and install the latest device drivers system from our wiki site: Device Drivers
- Start RadiMation®.
Otherwise, directly start with:
- Stop all tests and close all windows inside RadiMation®.
- Open from the main menu
Now you will see the default “Device Driver Settings” window:
- To access the advance device driver options open the corresponding settings .INI file: Hold the "SHIFT" button from the keyboard while clicking the "Advanced" button. (It is also possible to manually search and open the corresponding settings .INI file on your disk.)
- Add or search the requested parameter(s).
- Add or modify the parameter(s) value as requested.
- Close the .INI file and click “Save” when asked to save changes.
- Press Ok on to close the “Device Driver Settings”.
- Press close to close the configuration window.
Example 1
Set the turn table to go to 90 decrease as starting point and stop point at 270. Turn table used is the 2090
[EMCO2090] TurnAtStart=1 TurnToAtStart=90 TurnAtStop=1 TurnToAtStop=270
As you can see we have now modified the value of the parameter(s).
Example 2
Modify the frequency range of the Bonn BLWA 0820-160/75/50D.
[Frequencies] StartFrequency=1E+009 StopFrequency=2.7E+009
As you can see we have now modified the value of the StopFrequency parameter.