Difference between revisions of "RadiMation Application Note 154"
(Created page with "__NOTOC__ == How to perform a MIL-STD CS114, Conducted susceptibility, bulk cable injection test == This application note explains how the MIL-STD CS114, Conducted susceptibil...") |
(→Necessary equipment) |
||
| Line 11: | Line 11: | ||
* Coupler | * Coupler | ||
* Forward power meter | * Forward power meter | ||
| + | * Reflected power meter (optionally) | ||
* Current sensor | * Current sensor | ||
| − | * Sensor power meter | + | * Sensor power meter / Analyser |
* 50 Ohm load | * 50 Ohm load | ||
* 50 Ohm attenuator | * 50 Ohm attenuator | ||
| Line 18: | Line 19: | ||
* Current injection device | * Current injection device | ||
* Current injection calibration jig (Calibration fixture) | * Current injection calibration jig (Calibration fixture) | ||
| − | * | + | * Cable drivers with corrections |
== Configuration of the test sites == | == Configuration of the test sites == | ||
Revision as of 10:16, 16 October 2023
How to perform a MIL-STD CS114, Conducted susceptibility, bulk cable injection test
This application note explains how the MIL-STD CS114, Conducted susceptibility, bulk cable injection test can be performed with RadiMation®
The exact requirements and test methods for the CS114 are specified in the MIL-STD-461.
Necessary equipment
The following devices are necessary to execute this test:
- Signal generator
- Amplifier
- Coupler
- Forward power meter
- Reflected power meter (optionally)
- Current sensor
- Sensor power meter / Analyser
- 50 Ohm load
- 50 Ohm attenuator
- LISN
- Current injection device
- Current injection calibration jig (Calibration fixture)
- Cable drivers with corrections
