Difference between revisions of "Release Notes/Solved items Version 2015.1"

Revision as of 09:46, 10 March 2015

#2249: Not possible to set limit line from 500 Hz to 900 Hz
#4019: Unexpected CIC errors
#4733: No trace of the measurement data visible
#4748: QP measurements seems to be wrong
#5406: Peaks are detected outside the graph trace
#5563: Continuously measuring envelope power of the RadiPower results in memory problems
#5684: Unexpected high noise floor with CXA 9000A
#5818: Driver for R&S ESPC not working anymore after updating drivers.exe
#5821: VI Powermeter: Burst Graph doesn't show the graph by default
#5823: Driver: Teseq NSG 4070 as Amplifier and Powermeters
#5826: Error 76: Could not find a part of the path (..)
#5827: TSF files can't be deleted, delete and Ok buttons are always disabled
#5837: How can the field sensor be corrected by a RadiMation file?
#5846: R&S ESRP error Data out of range during time setting
#5848: Does the modulation needs to be turned off and on during each frequency step?
#5849: How can a customized warning message be shown?
#5857: GPIB Hibernated NI Drivers error required PC restart and loss of data
#5860: Frequency range of Agilent N5171B Signal Generator
#5862: How to add the correction for the emission antenna VW TL81000?
#5868: RadiMation is crashing when device is not connected

#5642: Driver Teseq NSG 4070 as Signal Generator
#5736: No trace data obtained from measurements with FSV13
#5739: Cursor information is no longer shown
#5778: Rigol spectrum analyser as powermeter is using pre-amp
#5780: Control of the Maturo antenna tower is not working if it is controlled with a LAN-to-GPIB convertor
#5790: Final measurement of QP detector on R&S ESI always returns 0 dBuV
#5797: R&S SME03 Specific system errors Level over range and ALC failure
#5800: Windows XP is not supported anymore
#5801: Detection if zeroing of RadiSense4 probe is finished takes a long time
#5803: Controls of the VI Powermeter are not reenabled if the auto-trigger is disabled during the re-trigger wait time
#5805: Old test results cannot be loaded in 2015.1.2
#5816: Rigol spectrum analyser pre-amp settings can't be controlled

#5787: Selection of another TSF folder doesn't update the list of TSF's in that folder
#5791: Uniform Field Area Calculation is not working for Constant Power method calibration files

@@ Line 1: / Line 1: @@
+{{:Release Notes/Solved items Version 2015.1.4}}
 {{:Release Notes/Solved items Version 2015.1.3}}
 {{:Release Notes/Solved items Version 2015.1.2}}
 {{:Release Notes/Solved items Version 2015.1.1}}