Difference between revisions of "Rohde & Schwarz ESU"
| Line 13: | Line 13: | ||
= Firmware = | = Firmware = | ||
The latests known firmware (at 2009, october 14th) is: 4.33 SP1. The release notes of that firmware version can be found [http://www2.rohde-schwarz.com/file/ESU_RN_4.33_sp1.zip here] | The latests known firmware (at 2009, october 14th) is: 4.33 SP1. The release notes of that firmware version can be found [http://www2.rohde-schwarz.com/file/ESU_RN_4.33_sp1.zip here] | ||
| + | |||
| + | = Time domain scan = | ||
| + | Using a very small RBW on higher frequencies in combination with the Time domain scan will result in big files. This is caused by the fact that the ESU is taking 4 measuring point for each frequency. The step size is determined by the RBW. | ||
| + | |||
| + | Possible solutions are: | ||
| + | * Bigger RBW at higher frequecies. | ||
| + | * Using the receiver mode in stead of the Time domain. | ||
= Links = | = Links = | ||
Revision as of 11:28, 26 October 2009
The ESU is a full compliant Spectrum analyzer/Receiver of Rohde & Schwarz.
The ESU is the replacement for the ESIB.
Documentation
The programmer manual can be found here
Features
The ESU has a new feature compared to the ESIB en the ESPI. LAN is standard. It has what is called time domain scan. which is FFT functionality to get spectrum. This FFT option is an additional option that you need to pay for. note that at this moment the FFT method is not a valid way of getting the spectrum compliant. but when using is a pre-compliant way of getting the frequencies of the peaks it is. known special limitations are:
- min span in time domain scan is 10 times the RBW
- pre amplifier, can only be use from 1 kHz in receiver mode.
- Pre amplifier, can only be used up to 3.6 GHz. for the full range you need a special option.
Firmware
The latests known firmware (at 2009, october 14th) is: 4.33 SP1. The release notes of that firmware version can be found here
Time domain scan
Using a very small RBW on higher frequencies in combination with the Time domain scan will result in big files. This is caused by the fact that the ESU is taking 4 measuring point for each frequency. The step size is determined by the RBW.
Possible solutions are:
- Bigger RBW at higher frequecies.
- Using the receiver mode in stead of the Time domain.
