Talk:RadiMation Application Note 100

I do have some suggestions to further improve the application note:

• The table of contents is shown twice
• Isn't it better to have a screenshot of the result in the introduction. It will make it clear how the result will be.
• The 'ScreenElement' macro can be used to indicate button names. I already modified it on a few locations. But not yet on all locations
• The 'Remove' button and the 'Custom Status window' checkbox are not explained.
• The section of 'Horizontal' or 'Vertical' doesn't show any text. Maybe it is better to provide a screenshot of the enhanced status window for each situation. Then the difference will be very clear...
• I Suggest to include a screenshot of an example after the 'List Of measurement parameters'.
• Then at the end of the document it is very helpful to show a screenshot during a test, where also the enhanced status window is shown
• In that last section it should also be explained that if the enhanced status window is closed, it can be shown again from the 'Window' menu.

Joro 10:01, 15 July 2015 (UTC)

• The table of contents is shown twice

-> removed the additional table of contents.

• Isn't it better to have a screenshot of the result in the introduction. It will make it clear how the result will be.

-> agreed inserted two screenshots of possible end results.

• The 'ScreenElement' macro can be used to indicate button names. I already modified it on a few locations. But not yet on all locations.

-> Good idea, will update the whole text and use it from now on.

• The 'Remove' button and the 'Custom Status window' checkbox are not explained.

-> Extended the explanation to include this.

• The section of 'Horizontal' or 'Vertical' doesn't show any text. Maybe it is better to provide a screenshot of the enhanced status window for each situation. Then the difference will be very clear...

-> Already had those screenshots ready to be implemented. Updated the text.

• I Suggest to include a screenshot of an example after the 'List Of measurement parameters'.

-> Already had this screenshots ready to be implemented. Updated the text.

• Then at the end of the document it is very helpful to show a screenshot during a test, where also the enhanced status window is shown

- > I agree and will create such screenshot and description.

• In that last section it should also be explained that if the enhanced status window is closed, it can be shown again from the 'Window' menu.

- > I agree, however I was not able to reopen this window after it was closed...

Sast 11:17, 14 August 2015 (UTC)

Ok. These improvements are very good additions. I further improved some sentences, and implemented some markup changes.

All is ok for me, but the the last section is very strange. You explain everything us Frequency, signal power and calculated field. Then at the end suddenly the calculated field is replaced by the Average field. I agree that it is described in the text, however it seems very unlogical. I suggest to create a new screenshot that shows: Frequency, Signal power and Calculated field. Maybe it is even better to show in this last section, a screenshot of the complete RadiMation window, including the test running, and the enhanced status window.

And we should investigate if it is possible to reopen the enhanced status window once it has been closed.

Joro 14:29, 27 August 2015 (UTC)