Difference between revisions of "Agilent Technologies N9310A"
(→Remote display on screen) |
|||
| Line 1: | Line 1: | ||
| + | The Agilent N9310A is a USB driven signal generator. | ||
| + | |||
= Manual = | = Manual = | ||
Programming manual can be found [[media:N9310.pdf|here]] | Programming manual can be found [[media:N9310.pdf|here]] | ||
| Line 26: | Line 28: | ||
* A red LED indicator is lit once the instrument is in remote | * A red LED indicator is lit once the instrument is in remote | ||
* A static bit map is displayed on the instrument’s screen, a refreshed screen is not available unless LOCAL mode is enabled. | * A static bit map is displayed on the instrument’s screen, a refreshed screen is not available unless LOCAL mode is enabled. | ||
| + | |||
| + | [[Category:Signal Generator]] | ||
| + | [[Category:RadiMation]] | ||
Revision as of 16:56, 24 January 2008
The Agilent N9310A is a USB driven signal generator.
Manual
Programming manual can be found here
Quike start + short programming manual can be found here
Remote display on screen
When controlled by software the device will display the following image:
We have received the following information from Agilent regarding this item
I confirm you that under remote control, it is normal that the display of your generator is not updated, please refer to FAQ: http://www.home.agilent.com/agilent/faqDetail.jspx?cc=US&lc=eng&ckey=1110361&nid=-536902260.536908604&id=1110361 Regarding USB control, it is normal that even when closing your VISA session the instrument stands under remote control, as last software layer "USB Test & Measurement Instrument" is still active, but you can take instrument control back by simply using Local key on the front panel of the N9310A.
The text on the web page:
The N9310A screen is not updated when the N9310A is running a program. When doing the same operation in LOCAL mode, the display is updated. Is there something wrong with my N9310A?
Running your N9310A in remote mode brings forward the following two symbols:
- A red LED indicator is lit once the instrument is in remote
- A static bit map is displayed on the instrument’s screen, a refreshed screen is not available unless LOCAL mode is enabled.
