Difference between revisions of "List of Application Notes"
| Line 21: | Line 21: | ||
* Application Note 119: [[RadiMation Application Note 119|How to basic configure a device]] | * Application Note 119: [[RadiMation Application Note 119|How to basic configure a device]] | ||
* Application Note 120: [[RadiMation Application Note 120|How to measure the HV-LV coupling attenuation]] | * Application Note 120: [[RadiMation Application Note 120|How to measure the HV-LV coupling attenuation]] | ||
| − | * Application Note 121: [[RadiMation Application Note 121|Using a RadiPower powermeter stand-alone with RadiMation® free | + | * Application Note 121: [[RadiMation Application Note 121|Using a RadiPower powermeter stand-alone with RadiMation® free]] |
* Application Note 122: [[RadiMation Application Note 122|Updating RadiMation]] | * Application Note 122: [[RadiMation Application Note 122|Updating RadiMation]] | ||
* Application Note 123: [[RadiMation Application Note 123|Implementing Switch Matrix design in RadiMation®]] | * Application Note 123: [[RadiMation Application Note 123|Implementing Switch Matrix design in RadiMation®]] | ||
Revision as of 07:52, 27 October 2020
The following application notes are present:
- Application Note 100: Enhanced Status Window
- Application Note 101: Optimize Height and Optimize Angle
- Application Note 102: Performing an ETSI EN300328 MIMO measurement
- Application Note 103: How to determine the antenna diagram of an antenna
- Application Note 104: How to determine the transfer impedance of a current sensor
- Application Note 105: Protection of changes in the RadiMation® configuration
- Application Note 106: Powermeter parameter configuration
- Application Note 107: How to provide detailed information of problems
- Application Note 108: How to perform a verification of calculations in RadiMation®
- Application Note 109: Configuration of RadiMation® on a network
- Application Note 110: How to perform Uniform Field Area (UFA) calculations
- Application Note 111: How to use the RadiCentre® safety interlock system in RadiMation®
- Application Note 112: How to perform Audio Break Through measurements
- Application Note 113: How to use the RadiMation® Global and Standalone configuration manager
- Application Note 114: How to measure data from the EUT using the Configurable AD Convertor device driver
- Application Note 115: How to measure amplifier harmonics using RadiMation
- Application Note 116: How to specify the antenna factor
- Application Note 117: How to update device drivers
- Application Note 118: How to request device driver creation
- Application Note 119: How to basic configure a device
- Application Note 120: How to measure the HV-LV coupling attenuation
- Application Note 121: Using a RadiPower powermeter stand-alone with RadiMation® free
- Application Note 122: Updating RadiMation
- Application Note 123: Implementing Switch Matrix design in RadiMation®
- Application Note 124: Emission: Measuring intermittent signals
- Application Note 125: Pontis Pecos: Using the Pontis Pecos device driver
- Application Note 126: Gain Compression
- Application Note 127: Report Generator: Build a custom emission table
- Application Note 128: Reading the output value of single antenna's separately of a isotropic probe
- Application Note 129: How to use the Schloeder CDG 6000
